If you plan to mount the ARB differential locks or to inflate the tires of your Wrangler JK, the ARB compressor will be very easy to install with the DFR 4X4 Compressor Bracket.
In the engine compartment of the JK it is almost impossible to find a hole to install the ARB CKMA12 compressor, even the smallest CKSA12, that's why DFR 4X4 has designed this specific bracket for the Jeep Wrangler JK both diesel and gasoline.
The compressor cables have access to the interior just below the bracket, reaching the interior of the cabin and the battery without problem.
Very easy to install bracket and accessible compressor for maintenance, away from heat, water and dust.
How to install:
1º We pre-installed the ARB compressor in the DFR 4X4 Support.
2º We will pass the cables of the buttons to the interior of the passenger compartment, through the cable gland on the right side of the vacuum tank of the brake pump.
3º Loosen the two nuts (without removing them) that hold the brake vacuum tank and remove the screw from the wing.
5º We put the wing screw and tighten the nuts first and finally the compressor